Asked by: Leonice Millan
automotive convertible

How do you take the door panel off a 1999 Chevy Tahoe?

Last Updated: 5th March, 2020

16
VIDEO

Click to see full answer.

Keeping this in consideration, how do you take the door panel off a Tahoe?

Insert the blade of your small flathead screwdriver in to the notch at the bottom edge of the trim piece behind the chrome door opener handle and gently pry it out. Set the trim panel aside in a safe place. Then pry out the rectangular trim panel located below the door pull handle at the center of the arm rest.

Likewise, how do you take the door panel off a 1998 Chevy Blazer? How To Remove Door Panel 98-05 Chevy S10 Blazer

  1. Remove the Phillips head screw inside the door handle.
  2. Remove the door handle bezel.
  3. Remove the two 7mm bolts from the door pull.
  4. Pry up the window switch panel by hand.
  5. Disconnect the door lock wiring harness.
  6. Disconnect the window switch wiring harnesses.
  7. Pry out the door panel with a door panel clip tool or putty knife.

Keeping this in consideration, how do you replace a door handle on a Chevy Silverado?

How To Replace Outside Front Door Handle 07-13 Chevy Silverado

  1. step 1: Removing the Door Panel (0:42) Pry off the trim piece inside the door pull with a flat blade screwdriver.
  2. step 2: Removing the Door Handle (3:23) Remove the 10mm bolt in the door.
  3. step 3: Installing the New Door Handle (5:09) Insert the lock rod from the handle.
  4. step 4: Reinstalling the Door Panel (5:57)

How do you replace a passenger side window?

  1. Inspect the damage carefully.
  2. Remove the door panel to access the remaining glass.
  3. Vacuum any debris and glass from the vehicle.
  4. Insert a brand new side window.
  5. Test the regulator to ensure the window functions properly.
  6. Replace the door panel.
  7. Clean all of the glass on your vehicle.

Related Question Answers

Irmina Scholze

Teacher

How do you take the door panel off a GMC Sierra?

GMC Sierra Door Panel Removal
  1. Remove the plastic triangle piece above the panel where the vent window normally is.
  2. Remove the control panel in front of the arm rest.
  3. The door lock slide lever just pops straight out of the hole.
  4. The plastic trim around the door handle snaps in also.
  5. There are two long screws that have to come out.

Yobany Jayo

Reviewer

How do you take the doors off a Chevy s10?

How to Remove Chevrolet S10 Door Hinge Pins
  1. Open the door. Locate the spring in the door jam. Use the 12-inch pry bar to pop the spring out of the door jam.
  2. Place the punch on top of the hinge pin next to the spring. Strike the punch with the hinge pin until you drive the pin out of the hinges.

Yarely Beisti

Reviewer

How do you take the door panel off a Yukon?

How To Remove Door Panel 99-02 GMC Yukon
  1. It is located near the mirror on the door panel.
  2. You can do this with your fingers.
  3. Gently pull the switch panel up and out.
  4. Disconnect the wiring in the switch plate.
  5. Remove the door handle bezel.
  6. Remove the two 7mm bolts.
  7. Unplug the seat heater by pushing in on the clip and pop it through the door panel.

Zhang Leiteritz

Beginner

How do you take the door panel off a Chevy Suburban?

How To Remove Front Door Panel 00-06 Chevy Suburban
  1. Pry up the window switch panel by hand.
  2. Disconnect the window switch wiring harness.
  3. Remove the two 8mm bolts behind the door pull.
  4. Remove the 8mm bolt from the bottom of the door panel.
  5. Pry off the mirror base trim piece by hand.
  6. Pry off the door handle bezel with a flat blade screwdriver.

Romaisa Gaede

Beginner

How do you take the back door panel off a Chevy Silverado?

How To Remove Rear Door Panels 07-13 Chevy Silverado
  1. Pry off the trim piece inside the door pull with a flat blade screwdriver.
  2. Pry off the trim piece inside the door handle with a flat blade screwdriver.
  3. Remove the two 10mm bolts inside the door pull.
  4. Remove the 10mm bolt inside the door handle.
  5. Pry out the upper panels by hand.
  6. Remove the upper door handles.

Onia Rayner

Beginner

How do you take a car door panel off?

Start by removing the window and power lock control panel. Pry it off with a screwdriver and then unplug the wires from it. Use a screwdriver to remove any screws holding the panel to the door. Grab the panel with both hands and pull it straight out to remove it.

Sylvain Gudoshin

Beginner

How do you change a window motor on a 2001 Chevy Silverado?

How to Replace the Window Motor in a 2001 Chevy Silverado
  1. Pry the window switch from the Silverado's door panel using a trim tool.
  2. Remove the hex-head screws from the door panel using the socket set.
  3. Lift the Silverado's door panel upward two inches to clear the lock knob before removing the panel from the door by hand.