Asked by: Siqi Mairu-Illar
food and drink non alcoholic beverages

Why does my NutriBullet smell?

Last Updated: 2nd April, 2021

33
When it gets close to the minute mark, it can start smelling like rubber burning on tires, turn it off!” Never blend hot items in the NutriBullet. It may work in other blenders, but this machine is not designed to handle warm or hot liquids. Keep the machine clean and avoid putting the blades in the dishwasher.

Click to see full answer.

Consequently, why does my NutriBullet smell like burning?

Not only blenders but every electric appliance is heated at some point. When electricity passes from a wire, it produces heat. If there is some material on the motor of blenders like oil droplets or some other material that burns with heat, then smoke or burning smell is produced.

Likewise, how do I get rid of the smell in my blender? Mix hydrogen peroxide, baking soda, and dish soap. Let the disassembled pieces sit in the mixture for a while. Turn the container part so that each side is soaking in the mixture for a while. Then rinse, wash all pieces with hot soapy water, and see if the smell is gone.

In this way, why does my blender stink?

If your blender has a funky smell coming from the jar (and how appetizing is that?), there's a quick fix you can use. Cut up a lemon and add it to the blender. Add a bit of water, say half a cup or so, and then blend. The lemon helps pull odours out of the blender jar and will leave the blender smelling lemony clean!

Can you put hot liquid in Nutribullet?

Do not put hot liquids in any of the blending vessels before blending. Start with cool or room temperature ingredients. The back of the NutriBullet also reiterates these safety instructions, stating “Do not operate continuously for more than one minute” and “NEVER blend warm, hot or carbonated ingredients”.

Related Question Answers

Arunas Gonser

Professional

Can a Nutribullet be used as a food processor?

A Nutribullet can replace a food processor. The two Nutribullet blades are very similar to those found in food processors; however, the capacity of a Nutribullet is less than most food processors. The two blades that come with a Nutribullet include the extractor blade and the milling blade.

Xinyi Uran

Explainer

How do you open the lid of a Nutribullet?

Run the Lid Under Hot Water
When a lid on a partially used jar is stuck, it could be glued shut. If you can't loosen it using a rubber glove, turn on the hot water and let it run until it reaches its maximum temperature. Hold the lid under the water for about 30 seconds.

Mian Velichko

Explainer

Is the Nutribullet noisy?

How noisy is the nutribullet? You never hear it on the informercial because they do voiceovers.

Matheo Losas

Pundit

Is the NutriBullet healthy?

Trendy Nutribullet blenders are healthier: They don't make blood sugar levels spike like juicers do. Trendy Nutribullet blenders could make fruit juice a healthy option again, by keeping blood sugar down. Health officials now advise drinking no more than 150ml of fruit juice a day because it is so high in sugar.

Mikki Silvares

Pundit

How do I use a NutriBullet?

How to Use Your NutriBullet
  1. Step 1: Unbox Your NutriBullet. Whether you're rocking a Magic Bullet, Rx, 600, PRO, or Balance, the first step is always the same.
  2. Step 2: Make a Smoothie, Any Smoothie. Look in your fridge and freezer.
  3. Step 3: Blend.
  4. Step 4: Drink Your Smoothie.
  5. Step 5: Clean Up.

Linwei Meton

Pundit

What do you do when your NUTRiBULLET stops working?

If the blades do not turn and you notice a burning smell, unplug the power base and let it cool for an hour. The powerbase will reset once the unit is unplugged.

Alban Bohigues

Pundit

Can NUTRiBULLET blades go dishwasher?

Do not put the blades in the dishwasher. Simply hand wash with warm soapy water. The NUTRiBULLET cups can be washed on the top rack of the dishwasher using the normal (not sanitize) cycle. The NUTRiBULLET cups and blades should not be sterilized in boiling water for any reason as this will warp the plastic.

Mesias Knipschild

Teacher

How do you clean the rubber seal on a NutriBullet?

Wash your blades by hand with warm, soapy water and a dish brush to loosen any stuck-on debris. If you want a deeper clean, rinse the blade with a 10% dilute vinegar and water solution or lemon juice.

Cristhian Grundemann

Teacher

Why is my NutriBullet leaking?

Try tightening the cup tighter to the base. If it continues to leak, you can easily slide off the rubber seal and replace it with a new one to create a new and lasting seal. It shouldn't leak. Smaller amounts leak less, but they then don't give enough yield.

Svetlozar Hromada

Teacher

How do you get rid of cinnamon smell?

To remedy any unwanted odors, turn to your spice drawer. Simply boil a few cinnamon sticks for two minutes and then turn the heat to low and let the warm, spiced scent waft through your home; turn the heat off once the pleasant smells take over.

Exuperancia Olivia

Reviewer

How do I clean a foggy blender?

How to Clean a Cloudy Blender
  1. Pour one cup of white vinegar into the container.
  2. Fill the contain half-full with warm water.
  3. Let the container soak in an upright, standing position for several hours or even overnight.
  4. Our the contents out and use a soft pot scrubber to clean the remaining residue.

Alexsander Gatjens

Reviewer

How do you clean the base of a blender?

Add dish soap: Add just a drop of dish soap. Turn on the blender: Put the blender pitcher back on the base and hold the lid down with a towel. Turn on the blender and let it run for about 10 seconds. Pour out the hot water and rinse: Rinse out the blender thoroughly with more hot water.

Ivor Lombardia

Beginner

How do you clean smoothie bottles?

Baking or bicarb soda found in most pantries can also be used to clean your drink bottles. Use a couple of heaped teaspoons of baking soda and warm water, mix together, and let soak for a few hours. Then rinse out with hot water and mild dishwashing detergent.

Xiaopeng Redo

Beginner

How do you get rid of bad protein smell?

Removing Odors
First, add three tablespoons of baking soda to 400mL of room temperature water. Then, shake the bottle up with the agitator attached. This chemical reaction should help to remove any pesky remains of protein shake that may have stuck to the bottle.